November 21, 2024, 10:33:06 PM
« previous next »
Pages: 1 [2]

Author Topic: Servo installation query  (Read 3633 times)

Offline Chris Sexton

  • Factory Specialist
  • Synergy Hero
  • *****
  • Posts: 2729
  • Admiral, There be whales here!
Re: Servo installation query
« Reply #15 on: February 05, 2014, 04:31:00 AM »
I always use the grommets but on the rjx I didnt. The servo hold tabs are a bit thick  and I had problems damaging the servo lead so I took the grommets out and mounted solid.

sent from my Verizon Samsung Galaxy Note 2

Logged
Chris Sexton
Synergy Factory Specialist / Rail Blades / Team Scorpion

Offline MadBird

  • Member
  • **
  • Posts: 54
Re: Servo installation query
« Reply #16 on: February 05, 2014, 04:50:31 AM »
Yeah, I've noticed with the cyclics that where the lead enters the case it is a very tight up against the upper bearing block. I was considering chamfering the back side of the bearing block, but hard mounting the servos might be an easier task.
 
Logged

Offline Rodney Kirstine

  • Field Representative
  • Synergy Hero
  • ****
  • Posts: 2112
Re: Servo installation query
« Reply #17 on: February 05, 2014, 03:31:00 PM »
I hard mounted the RJX servos on mine.
Logged
Rodney

Team Synergy
Pages: 1 [2]
« previous next »