Parts compatibility

[daniel_654]

Hey Guys,

Just curious are some of the parts from the E7 interchangeable with the N7 i.e. complete tail assembly, feathering shaft, main shaft, etc. And yes.. I had an accident lol.

Any help here would be appreciated!

Thanks, Daniel

[Ross Lawton]

Hi Daniel,

The N7 does share some of its parts with the E7se/E5 and also the N5c, this is one of the great things about Synergy Helicopters is the cross compatibilitiby of parts.

The tail rotor assembly is essentially all E5 apart from a few minor differences like the N7 specific tail fin. The main rotorhead is the same as used on the E7se so the feathering shaft will be the same, however the main shaft is N7 specific.

Dealers are starting to receive N7 parts so check with your local Synergy dealer or check out the Synergy R/C Helicopters online store at https://www.mattbotos.com/store/

http://www.experiencerc.com/store/317-410_main_shaft-p-16471.html

Hope this helps,
Cheers,
Ross

[daniel_654]

Thanks. Yes I just checked the synergy online store and found everything I need.

Thanks again,

Daniel

[daniel_654]

What about the TT and Tail boom etc?

[Ross Lawton]

Hi Daniel,

The boom and torque tube are the same parts used on the E7se.

The part number for the boom is:- 315-140
The part number for the Torque Tube is: 320-500

The torque tube is supplied as a bare tube so it will require the additional purchase of the bearings/guides and drive ends or the reuse of the existing items if you can remove them without damaging them.

Hope this helps,
Cheers
Ross

[daniel_654]

yes I found everything I need except a feathering shaft...

DL

[Ross Lawton]

Hi Daniel,

That's great to hear, if you need the head axle part number it is: 120-114.

Hope this helps and you get her repaired and back in the air soon. 

Cheers,
Ross

[daniel_654]

Sure will. Just another lesson of flying right at dusk!