N7 - CGY750 setup

[smith512]

Finishing up my new N7 and doing the CGY750 setup (V1.4).  In order to get 10deg of cyclic during the setup, my swash rate percentage is 73%.  CGY750 manual says 50-70% is ideal.    Should I consider long balls on the inner swash like we used to do?  Am I sweating too much over nothing?  Thanks in advance.

Steve

[flyalan]

73 is fine... enjoy!

Cheers
Alan

Sent from my SM-N900V using Tapatalk

[Kevin Feil]

Congrats on the New Machine Steve, keep us posted on the Madien.

Best Regards,

Kevin

[flyalan]

Steve
Matt has mentioned elsewhere that 75 was a bit too high so you may want to change out the balls like you were thinking.
I have ran slightly greater than 70 on the old head on the n5c without a problem. That of course was with the prior firmware. My bad...

Cheers
Alan

Sent from my SM-N900V using Tapatalk

[Kevin Dalrymple]

Steve i ran mine on Saturday at 85 that gave me 11 degrees of cyclic pitch. But I ended up with 10 degrees. The manual says 9-10. Most guys on the forums are at 10. To low and the Heli will pitch up in FFF. To high and it will be sensitive.

[smith512]

Well I was actually at 75% Swash Rate to get 10 degrees of cyclic.  Just didnt sit OK with me, so I put long balls on the inner swash.  Now I am at 66% at 10 degrees of cyclic and feel better about it.  Will maiden tomorrow and get the motor broken in and let her rip.

OS 91 HZ-R Speed 3D w/ Powerboost pipe, gonna see if it can handle 13 degrees of collective. :-)

Steve

[Chris Sexton]

Well I was actually at 75% Swash Rate to get 10 degrees of cyclic.  Just didnt sit OK with me, so I put long balls on the inner swash.  Now I am at 66% at degrees of cyclic and feel better about it.  Will maiden tomorrow and get the motor broken in and let her rip.

OS 91 HZ-R Speed 3D w/ Powerboost pipe, gonna see if it can handle 13 degrees of collective. :-)

Steve

I run my OS91 3D Speed Black with Hatori pipe on 13 degrees of Collective pitch all day long. Pulls like a train Love it.