December 04, 2024, 08:26:53 PM
« previous next »
Pages: [1]

Author Topic: My new Synergy E5  (Read 1418 times)

Offline Helikid42

  • Newbie
  • *
  • Posts: 14
My new Synergy E5
« on: September 19, 2017, 04:51:16 PM »
Just opened my Synergy E5 today to check over things. Was not to pleased to see a few marks/scratches and even jagged edges on the head block and one blade grip. I'm almost certain that it was caused by shipping and handling by the retailer. Other than that, I am so excited to start building it and see what other tips and tricks other E5 pilots might have.
Logged

Offline Rodney Kirstine

  • Field Representative
  • Synergy Hero
  • ****
  • Posts: 2112
Re: My new Synergy E5
« Reply #1 on: September 19, 2017, 06:30:16 PM »
Well, that's a bummer.  Have you brought it up with the retailer you bought it from?  Snap some pictures and see what they say.  If you run into a roadblock there, let us know.
Logged
Rodney

Team Synergy

Offline curmudgeon

  • Synergy Veteran
  • *
  • Posts: 578
Re: My new Synergy E5
« Reply #2 on: September 19, 2017, 08:18:48 PM »
Consider purchasing two T-handle 4mm hex drivers and a 8mm Grippy to loosen the main blade grips off the spindle shaft without hurting your hands.
Logged

Offline Richard Rollins

  • Field Representative
  • Synergy Veteran
  • ****
  • Posts: 553
Re: My new Synergy E5
« Reply #3 on: September 20, 2017, 04:29:08 PM »
The Grippy is a great investment for sure.
Logged
Rick
Team Synergy Team Rails, Team Scorpion
Pages: [1]
« previous next »