e7se tail slider

[giles]

I need to replace the bearings in the tail pitch slider ring. But having trouble removing them. Ive tried heating in an oven but they wont budge. The issue is there not alot of bearing inner to hit against to push it out from the other side.

[Cliff Chmiel]

stock slider, or the upgraded one, stock one has the plastic and a special washer that lock the bearing in, very hard to remove and replace. I put the new one on both my ships, they are well worth the money

[giles]

its an aluminium ring, not sure if its an upgrade or not. Anyway I managed to tap out the old bearings. took some doing. also I bought the heli used so who ever built it left out the brass bushing that sits between the bearings.

[Cliff Chmiel]

Check out fbl and see what you have, also on this site you can down load the manual, look in tread on the e5 there talking about the stock slider

[Manyc]

How did you tap them out? Is the a lip in the middle? Just trying to replace them myself.. It's the metal one...



Sent from my SM-G920I using Tapatalk

[Gabriel Sandoval]

I have a blind hole bearing removal kit that I use to pull bearings.
https://www.amazon.com/Bearing-Puller-Internal-Extractor-Remove/dp/B013U0E5YS/ref=sr_1_6?ie=UTF8&qid=1491664999&sr=8-6&keywords=blind+hole+bearing+puller+set

[giles]

How did you tap them out? Is the a lip in the middle? Just trying to replace them myself.. It's the metal one...



Sent from my SM-G920I using Tapatalk

while back now when I removed them. It was a combination of heating in the oven and tapping from the over side with a sharp tool like a small flat head screw driver to just catch the inner race. Mine was missing the brass spacer so don't know if this made it easier. The lip is the same diameter as the inner race so making it difficult to remove. I think once you get one bearing out the other one is easier to get too as you can aim the screw driver better as there is no bearing there to get in the way.

Thanks Gabriel for the bearing remover link. 

[Manyc]

Thanks..it's kind of what I figured but hoped it wasn't.. Bearing puller looks good.. But I don't think it does a bearing this small? Or does it?

Sent from my SM-G920I using Tapatalk