November 21, 2024, 04:04:39 PM
« previous next »
Pages: [1]

Author Topic: Nitro OS 55 HZR clicking noise  (Read 1813 times)

Offline rmarlan

  • Newbie
  • *
  • Posts: 15
Nitro OS 55 HZR clicking noise
« on: October 23, 2017, 09:46:28 PM »
Just completed engine rebuild bearings and piston ring.  Engine starts and runs great - but there is a loud clicking noise. The clutch is properly aligned - I don't see anything rubbing.  This is the video. 

https://goo.gl/6B3hNy

Any ideas? Thanks.

Bob
Logged

Offline Chris Sexton

  • Factory Specialist
  • Synergy Hero
  • *****
  • Posts: 2729
  • Admiral, There be whales here!
Re: Nitro OS 55 HZR clicking noise
« Reply #1 on: October 24, 2017, 07:30:57 AM »
Sounds like either the clutch stack or the fan hitting the shroud.  Can you hold the starter hex still while the engine is running without it dieing?

If you spin the sharter and engine by hand is that noise there>?
Logged
Chris Sexton
Synergy Factory Specialist / Rail Blades / Team Scorpion

Offline Gabriel Sandoval

  • Field Representative
  • Sr. Member
  • ****
  • Posts: 322
  • If your not crashin' your not trying hard enough..
    • Midwest Heli Boyz
Re: Nitro OS 55 HZR clicking noise
« Reply #2 on: October 24, 2017, 09:09:12 PM »
Sounds like the fan rubbing the housing, but as Chris mentioned clutch stack alignment can be off and cause this noise as well
Logged
Team Synergy
Team Scorpion
Team Dee Force Aviation
Team YS Performance USA
Looking for a fuel Sponsor

Offline rmarlan

  • Newbie
  • *
  • Posts: 15
Re: Nitro OS 55 HZR clicking noise
« Reply #3 on: October 24, 2017, 09:55:02 PM »
Found the issue.  Not enough locktite on the clutch that was rubbing on the bottom of the bell!  Fixed and now running perfectly.  My OS 55HZR just had the Magnum Fuel Bushing Mod.  No more rear bearing issues.  Runs great.  Love my N5C - currently have N7 under construction.  Which child will I love the most?  :D.

Thanks for the help.  Bob
Logged
Pages: [1]
« previous next »