Cyclic servo sapcers

[beans07]

Hi guys, not sure if I am re posting but if you are running Outrage BL servos (MKS also) you will need spacers behind the cyclic servos to make them fit in the frames. They are quite a long servo.

[churchyj]

MKS servos are best run with a set of the metal servo hold downs behind the servo to space them a little.  This posses no issues to any of the servo configuration.

[beans07]

I managed to get the spacing just right. The synergy E7 is the only (besides logo600) setup I have ever had on vbar that has 0 points trim, 0 ponts swash level and 0 points needed at top and bottom stick . I would say I got the geometry for vbar perfect.
 
-I used the carbon horn behind the plastic horn on all 3 servos.
-ball facing the front.
 
-1 x carbon spacer from Trex600/700 (2-3 synergy metal servo plates) on the front 2 cyclics and none on the back cyclic servo.
 
-Used the setting in the manual for the servo linkage.

[Adam.Melton15]

To get the outrage servos to fit I bought some Quick Uk servo spacers which are slightly thicker to the ones the kit comes with. I used one on one side of the servo then i use the rubber grommet then another spacer on the other side. This seems to align the servos perfectly. Here are a few pictures to give you an idea!




[attachment deleted by admin]