November 22, 2024, 05:48:54 AM
« previous next »
Pages: [1]

Author Topic: Head Block  (Read 1011 times)

Offline RyanW

  • Full Member
  • ***
  • Posts: 162
Head Block
« on: January 02, 2013, 11:23:16 AM »
Sorry if this has been asked before, but is the E5 head block the same size as the E6/E7  i.e. can you use the E5 one piece block on the E7?

Thanks!
Logged
-Ryan

Offline Darren Lee

  • Field Representative
  • Synergy Veteran
  • ****
  • Posts: 620
Re: Head Block
« Reply #1 on: January 02, 2013, 01:45:30 PM »
It's different, the hole in the main shaft would not line up.  Matt has mentioned that he's doing a new E6/7 head in the same style though...
Logged
Team Synergy / Rail Blades / Morgan Fuel

Offline Chris Sexton

  • Factory Specialist
  • Synergy Hero
  • *****
  • Posts: 2729
  • Admiral, There be whales here!
Re: Head Block
« Reply #2 on: January 02, 2013, 02:06:47 PM »
Can run the E5 main shaft and E5 block with E7 grips and feathering shaft though.

Lowers the rotor disk some too.
Logged
Chris Sexton
Synergy Factory Specialist / Rail Blades / Team Scorpion
Pages: [1]
« previous next »