November 01, 2024, 05:29:12 AM

Author Topic: Any plans for a 25mm spacing motor mount?  (Read 1795 times)

Offline stevehof

  • Full Member
  • ***
  • Posts: 145
Any plans for a 25mm spacing motor mount?
« on: October 24, 2011, 09:20:40 AM »
I would like to try an Xera motor that uses 25mm...

Offline ElectricSheep

  • Newbie
  • *
  • Posts: 17
Any plans for a 25mm spacing motor mount?
« Reply #1 on: October 24, 2011, 11:58:23 AM »
+1!

Steve, which one? I'd like to try my 4030/2.5Y (560kv) on 10S with the E6 boom. That was my favorite 10s motor on a 600-sized heli...




Tapatalk on iPhone

Offline stevehof

  • Full Member
  • ***
  • Posts: 145
Re: Any plans for a 25mm spacing motor mount?
« Reply #2 on: October 24, 2011, 12:25:39 PM »
+1!

Steve, which one? I'd like to try my 4030/2.5Y (560kv) on 10S with the E6 boom. That was my favorite 10s motor on a 600-sized heli...




Tapatalk on iPhone
I am thinking of the 4035/2.5y-480 on 12s. I emailed Xera and it looks like 75 continuous amps to 150+ max so it should be a noticeable step up in power from the Hacker 470 without the battery killing amp draw of  the super motors. It is available in a long shaft 6mm. Xera motors are reputed to run cool too. Did you find that to be the case with your 4030?

Anyway, I like my Hacker 470 fine. Just thinkin' out loud for the next build.

Offline Matt Botos

  • Synergy Hero
  • **
  • Posts: 1573
    • Matt Botos
Re: Any plans for a 25mm spacing motor mount?
« Reply #3 on: October 28, 2011, 02:26:27 AM »
Hey guys,

I've only had a couple requests for a 25mm motor mount.
Problem is that the 25mm spacing is going away. It does not provide enough room for a large enough motor shaft bearing. If I get enough requests I will see what I can do to accommodate.

Thanks,

Matt