Welcome,
Guest
. Please
login
or
register
.
Did you miss your
activation email
?
Home
Help
Search
Login
Register
November 01, 2024, 03:20:00 AM
Synergy Tech Support
»
Synergy Nitro Helicopters
»
Synergy N7
»
Had an issue mounting servos
« previous
next »
Print
Pages: [
1
]
Author
Topic: Had an issue mounting servos (Read 960 times)
Roger
Full Member
Posts: 221
Had an issue mounting servos
«
on:
May 27, 2014, 09:00:20 AM »
I ran into a clearance problem mounting my L/R cyclic servos last night. The servo cable would not allow the servo to swing into position. I had to pull the top bearing plate loose and raise it up to allow the cable to clear the plate. Perhaps a build mod to install the servos before the rear frame is attached to the bearing plates would be better. What are your thoughts on that and has anybody else had this issue?
ROG
PS. the manual shows a servo with no cable. piece - o - cake like that.
Had another thought. Don't put thread lock on the screws that hold the top plate until the servos are installed. That might be the best fix.
«
Last Edit: May 27, 2014, 09:15:32 AM by whitehedr
»
Logged
ROG
Retired Old Guy
Ross Lawton
Factory Specialist
Synergy Veteran
Posts: 793
Re: Had an issue mounting servos
«
Reply #1 on:
May 27, 2014, 10:02:00 AM »
Hi Whitehedr,
What servos are you running?
Some servos like the BK Servos and RJX have a larger rubber grommet where the wire exits the servo case and this does'nt allow much flex when installing into the main mechanics.
Hope this helps,
Ross
Logged
Team Synergy - UK
Roger
Full Member
Posts: 221
Re: Had an issue mounting servos
«
Reply #2 on:
May 27, 2014, 10:57:22 AM »
Yep, the large rubber grommet of my RJX servos is what caused the grief.
ROG
Logged
ROG
Retired Old Guy
Print
Pages: [
1
]
« previous
next »
Synergy Tech Support
»
Synergy Nitro Helicopters
»
Synergy N7
»
Had an issue mounting servos