November 22, 2024, 08:08:59 AM
« previous next »
Pages: [1]

Author Topic: 4 extra washers?  (Read 1420 times)

Offline peteowlsmith

  • Member
  • **
  • Posts: 74
4 extra washers?
« on: June 03, 2015, 04:48:32 PM »
Finishing off the airframe, and I have 4 extra guests   :o

All are stainless steel  -  11.90 OD  x 8.00 ID     .    Two are .48 thick ----  two are .78 thick ?
Logged

Offline Mike Spano

  • Synergy Hero
  • **
  • Posts: 1038
Re: 4 extra washers?
« Reply #1 on: June 03, 2015, 04:59:05 PM »
did you install your shims in  your head? between the damper and the radial bearings on the head axle?
Logged
Team Synergy
Rail Blades
TRM Power
Team Byron Fuels
MKS Servos

Offline peteowlsmith

  • Member
  • **
  • Posts: 74
Re: 4 extra washers?
« Reply #2 on: June 03, 2015, 06:24:30 PM »
 :)     Yep.

It is like they are "spares" if there is any end play, which there isn't.

Logged

Offline Mark Dean

  • Field Representative
  • Full Member
  • ****
  • Posts: 221
4 extra washers?
« Reply #3 on: June 03, 2015, 07:03:19 PM »
You are correct. The washers are shown on the fly barred assembly page a46.
There are three sizes to get the play out of the blade grips.   (Thin) 106-801 8x.5mmWasher (Med.) 106-802 8x.75mmWasher (Thick) 106-803 8x1mm Washer.

Mark


Sent from my iPhone using Tapatalk
« Last Edit: June 03, 2015, 07:07:28 PM by Deanmarkj »
Logged
Team Synergy Field Representative, Rail Blades, Scorpion Power Systems

Offline peteowlsmith

  • Member
  • **
  • Posts: 74
Re: 4 extra washers?
« Reply #4 on: June 03, 2015, 07:46:52 PM »
phew - I have a FBL unit  --- and now some extra washers   8)
Logged
Pages: [1]
« previous next »