November 23, 2024, 05:53:28 AM

Author Topic: Flybarless Head Problem  (Read 1781 times)

Offline Scooterpilot

  • Newbie
  • *
  • Posts: 21
Flybarless Head Problem
« on: November 21, 2011, 03:25:05 PM »
FBL Blade Grip Arm ( 520-514) is attached to the FBL Min Blade Grip (520-514) using two 3x6 Socket Head Screws ( 100-308).  I assembled the first Arm to the Grip without issue.  While installing the second Arm to the second  blade grip I noticed the Socket head screw closest to the blade does not screw in flush to the grip arm. If I try to tighten the bolt so the bolt head is flush to the Grip Arm the end of the bolt will contact the Radial Bearing inside the the blade grip.  There is enough space between the bottom of the  head of the bolt and the Grip Arm that I can place a thick lock washer to fill the gap.   

I don't want to cut the bolt, reason being , the to other blade went together without issues.

Any ideas?

[attachment deleted by admin]
« Last Edit: December 04, 2011, 11:45:35 AM by Forum_Nazi »
Chuck
N7 OS105 Hatori Pipe
18SZ

Offline Darren Lee

  • Field Representative
  • Synergy Veteran
  • ****
  • Posts: 620
Re: Flybarless Head Problem
« Reply #1 on: November 21, 2011, 05:15:53 PM »
The screws aren't supposed to be the same length...outboard one is shorter.
« Last Edit: December 04, 2011, 11:46:04 AM by Forum_Nazi »
Team Synergy / Rail Blades / Morgan Fuel

Offline Scooterpilot

  • Newbie
  • *
  • Posts: 21
Re: Flybarless Head Problem
« Reply #2 on: November 21, 2011, 08:31:02 PM »
Darren,

Whelp, that's what I get for working into the weeeeeee hrs of the night and building.  Thanks for that!!!!  The bolts are two different part numbers...the manual could not have been more clear on the assembling the head.

Thanks You!

Chuck
« Last Edit: December 04, 2011, 11:46:19 AM by Forum_Nazi »
Chuck
N7 OS105 Hatori Pipe
18SZ

Offline rpletts

  • Newbie
  • *
  • Posts: 3
  • EMC Corporation
Re: Flybarless Head Problem
« Reply #3 on: December 02, 2011, 04:35:13 PM »
I'm converting the N5 to FBL and bought the Synergy head to convert. Which hole in the head block do I use for the jesus bolt? Are the 80mm rods re-usable on the new head? Thanks.  ;)
« Last Edit: December 04, 2011, 11:46:31 AM by Forum_Nazi »

Offline Tommy Wagner

  • Field Representative
  • Sr. Member
  • ****
  • Posts: 418
Flybarless Head Problem
« Reply #4 on: December 02, 2011, 05:12:33 PM »
With The rods being that long you will have to go to the highest head position and that would be the lowest hole


Tommy

Sent from my iPhone using Tapatalk
« Last Edit: December 04, 2011, 11:46:40 AM by Forum_Nazi »