HeliJive 120 question

[Chris Sexton]

I know this isn't a Jive support forum, but apparently Kontronik made Mr Mel take his videos down about their products. I am new to HeliJives and I want to set my ATVs so I can have a more accurate understanding of how my gov is going to work.

I can't find any information on how to do it. Any of you Synergy fans have one of these controllers on your bird and can help me out?

For reference I am running:
Xera 4530-500 10p
HeliJive 120 /w heatsink v11
Mode 6 - gov

[steffgiguere]

Throttle curve 0 - 50 - 100. End points say 60 - 60

Put your throttle stick all the way up plug in your ESC. Then move up your high stick end point until the esc arms. Unplug your ESC. For the bottom end point put the same number as where the high stick armed at. Say your esc armed at 86 on high then put low stick end point at 86. Your done, hope this is clear.

[Chris Sexton]

Sounds very similar to my castle process, thanks!

[steffgiguere]

Yes, only with Castle you up the lower end point until your esc arms, with Kontronik you set the same has high point.

[Chris Sexton]

I was able to update my speed controller and my ATVs thank you for the help.


Sent from my iPhone using Tapatalk

[steffgiguere]

Sounds great, now have fun flying.