June 15, 2024, 09:38:37 PM

Author Topic: Futaba tail servo  (Read 1819 times)

Offline JVZ

  • Member
  • **
  • Posts: 78
Futaba tail servo
« on: January 20, 2012, 07:35:31 PM »
Which horn and hole position are you all using on your Futaba tail servos? I will be using a BLS251...

Offline seldred

  • Sr. Member
  • ****
  • Posts: 327
Re: Futaba tail servo
« Reply #1 on: January 20, 2012, 07:41:38 PM »
Use the t shaped horn on the furthest hole out.

Best regards,
-Steve Eldred

Offline steffgiguere

  • Field Representative
  • Synergy Hero
  • ****
  • Posts: 1373
Re: Futaba tail servo
« Reply #2 on: January 20, 2012, 07:43:03 PM »
Same here.
Team Synergy, Canada

Offline Chuck Bole

  • Field Representative
  • Synergy Veteran
  • ****
  • Posts: 631
Re: Futaba tail servo
« Reply #3 on: January 20, 2012, 07:48:42 PM »
 I use the + shaped horn and put the ball in the farthest hole out also. On both BLS251 and BLS 256 servos.

chuck
Team Synergy Field Representative / Thunder Power

Offline JVZ

  • Member
  • **
  • Posts: 78
Re: Futaba tail servo
« Reply #4 on: January 20, 2012, 07:54:30 PM »
thanks !

Offline p johnston

  • Field Representative
  • Member
  • ****
  • Posts: 55
Re: Futaba tail servo
« Reply #5 on: January 20, 2012, 08:18:58 PM »
Or 16.5mm...

Offline Jean-Luc Bolduc

  • Field Representative
  • Synergy Veteran
  • ****
  • Posts: 614
Re: Futaba tail servo
« Reply #6 on: January 21, 2012, 07:29:19 AM »
I use the thick T horn on the last hole outwards.  No flex here.
Team Synergy