Hello, new N5C TT user is coming

[ducatman2]

Thanks!

So, I am going to start the assembly.

First question, could you confirm me my tank assembly os good?

See pictures below, it seems in this particular position, the clunk does not reach the below part of the tank.

I use a clunk and a spécial tank tubing from lynx.



envoyé  depuis mon Sony Xperia Z1 avec Tapatalk 4

[Chris Sexton]

Looks good to me!! Good choice in the fuel magnet style clunk!

[ducatman2]

But if during a flight I stay in this position with not a full tank?

envoyé  depuis mon Sony Xperia Z1 avec Tapatalk 4

[ducatman2]

Stop for tonight. My first step:



envoyé  depuis mon Sony Xperia Z1 avec Tapatalk 4

[Rodney Kirstine]

But if during a flight I stay in this position with not a full tank?

envoyé  depuis mon Sony Xperia Z1 avec Tapatalk 4

Once you fill the tank with fuel, the MOAS will soak up some of the fuel and will sink.  I have these in my N5C and N7 and they both just kind of hung in the air like that until I filled the tank the first time.

[ducatman2]

Ok. It's clear. Thanks

Small additionnal question:

The position of the small void on the side of the antirotation guide is important or not? Left or right side?

There is no advice in the manual.



envoyé  depuis mon Sony Xperia Z1 avec Tapatalk 4

[ducatman2]

Picture

envoyé  depuis mon Sony Xperia Z1 avec Tapatalk 4

[Mark Burberry]

Nope, either side will do.

Cheers,
Mark

[Kevin Dalrymple]

That void is not use on the N5C. It is used on the N9

[ducatman2]

Hello,

New question:

Do you have the same?

It seems the diameter of servos screws is very smaller than the servo holes.

So, then integrated, there a lot of slack.

envoyé  depuis mon Sony Xperia Z1 avec Tapatalk 4

[flyalan]

I would not use the eyelets. The servo plate will do a very good job of holding the servo in place without the eyelets. The plate clamps down on the grommets and that in itself will do the job.
Cheers
Alan

Sent from my SM-N900V using Tapatalk

[ducatman2]

In progress:



envoyé  depuis mon Sony Xperia Z1 avec Tapatalk 4

[Mike Spano]

I don't even use the rubber. I hard mount all of my servos now, and I am loving it. no rubber to get stuck all over my servos, the plates, or the blocks. just use locktight and all is good. (at least for me it has been anyway)

[ducatman2]

Thanks.

Below, some new pictures:









New question:

It seems the gap between the canopy and the main gear is very small. What is your opinion?

[Chris Sexton]

Yeah it can be a touch close. You can add some shims under the rear canopy mounts. Or you can gently warm the canopy with a heat gun and reshape the canopy a touch.

sent from my Verizon Samsung Galaxy Note 2