CC Edge 160 settings

[Grimmy]

I'm looking for what others have their settings at on there CC Edge 160 for the 4530-500 Scorpion motor.  Like for gains, timing, ect.  I don't have the software in front of me to know the other settings to ask.

Thanks in advance.

[kym]

Brake Ramp: Immediate (*)
Brake Delay: .6 sec (Delayed) (*)
Current Cutoff Type: Soft Cutoff (*)
Power-On Beep: Enabled (*)
Auxiliary Wire Mode: Disabled (*)
Data Log Enabled: 1023
Current Limiting: Disabled
Auto-Lipo Volts/Cell: 3.2 Volts/Cell (*)
Voltage Cutoff Type: Soft Cutoff (*)
Hex55: 85
Vehicle Type: Helicopter
Throttle Type: Governor Mode
Throttle Response: Medium (5) (*)
Governor Gain: 20
Initial Spool-Up Rate: Medium (5) (*)
Head Speed Change Rate: 18
Auto Rotate Enabled: True
Governor Mode Type: Fixed
Vehicle Setup - Battery Type: LiPo
Vehicle Setup - Number of Cells: 12
Vehicle Setup - Battery Voltage: 44.40
Vehicle Setup - Gear Ratio: 10.08
Vehicle Setup - Motor Kv: 540
Vehicle Setup - Motor Number of Poles: 10
Desired Head Speed 1: 1800
Desired Head Speed 2: 1900
Desired Head Speed 3: 2000
Cutoff Voltage: Auto Li-Po (*)
Sample Frequency: 1 Sample / Sec (*)
PWM Rate: 8 Khz
Motor Timing: High (15)
Brake Strength: 0%, Disabled (*)
Direction: Forward (*)
Motor Start Power: Medium (59) (*)
Automatic Data Reset: Disabled (100%) (*)
Link Live Enable: Disabled (*)

hope this helps.

[Grimmy]

Sweet, thanks!!