November 23, 2024, 01:28:38 PM
« previous next »
Pages: [1]

Author Topic: Build help  (Read 1449 times)

Offline Manyc

  • Newbie
  • *
  • Posts: 10
Build help
« on: February 07, 2016, 02:23:41 AM »
Hello..  I have managed to score my kit already and have started the build..  However the shim that is meant to go between the auto hub and the bottom bearing block will not fit...

Any ideas?

Thanks
Logged

Offline Chris Sexton

  • Factory Specialist
  • Synergy Hero
  • *****
  • Posts: 2729
  • Admiral, There be whales here!
Re: Build help
« Reply #1 on: February 07, 2016, 06:04:55 AM »
It is tight on purpose. The bearings need a little preload. The easiest way is to loosen the lower bearing block, insert the shim and tighten it all up. Once the blocks are snug down it will spin free and you're thrust bearings will be happy.


Sent from my iPhone using Tapatalk
Logged
Chris Sexton
Synergy Factory Specialist / Rail Blades / Team Scorpion

Offline Manyc

  • Newbie
  • *
  • Posts: 10
Re: Build help
« Reply #2 on: February 07, 2016, 01:07:50 PM »
Thanks... Will try tonight..  Build is coming along
Logged

Offline Manyc

  • Newbie
  • *
  • Posts: 10
Re: Build help
« Reply #3 on: February 08, 2016, 01:54:47 AM »
Thanks worked a treat..  There is zero play in the main shaft..
Logged
Pages: [1]
« previous next »