November 21, 2024, 03:41:11 PM

Author Topic: Landing Gear dampners  (Read 1472 times)

Offline jayster10

  • Member
  • **
  • Posts: 65
Landing Gear dampners
« on: March 02, 2016, 02:02:23 PM »
Looking for a consensus on whether or not to use the landing gear dampeners on my N5C. Anyone have any input?

Offline Mike Spano

  • Synergy Hero
  • **
  • Posts: 1038
Re: Landing Gear dampners
« Reply #1 on: March 02, 2016, 02:22:57 PM »
what are you referring to Jay?

rubber rings like the old Align helis used to have on their skid tubes? if so, I would say no, they can cause the heli to stick to asphalt instead of slide, causing issues. IMO
Team Synergy
Rail Blades
TRM Power
Team Byron Fuels
MKS Servos

Offline jayster10

  • Member
  • **
  • Posts: 65
Re: Landing Gear dampners
« Reply #2 on: March 02, 2016, 02:59:44 PM »
Mike,

Yeah, those are what I am referring to. I was thinking they would be useful to protect the landing gear, but really they are not very expensive so would just replace when needed.

Thanks for the input.

Offline Mike Spano

  • Synergy Hero
  • **
  • Posts: 1038
Re: Landing Gear dampners
« Reply #3 on: March 02, 2016, 03:57:31 PM »
that's what I would do. I promise that if you go to land on asphalt or concrete, and you are not going straight down, they COULD cause a tip over. they probably wont every time, but they could, so I just don't use them, never did.
Team Synergy
Rail Blades
TRM Power
Team Byron Fuels
MKS Servos

Offline cml001

  • Field Representative
  • Synergy Veteran
  • ****
  • Posts: 684
Re: Landing Gear dampners
« Reply #4 on: March 03, 2016, 12:53:35 PM »
Skid nuts... Nope!
Clay
I can fly helicopters... Upside down!

Offline Cliff Chmiel

  • Synergy Veteran
  • *
  • Posts: 588
  • Cliff
Re: Landing Gear dampners
« Reply #5 on: March 03, 2016, 01:12:46 PM »
I like skidding auto too, not for me
Cliff

Offline Gabriel Sandoval

  • Field Representative
  • Sr. Member
  • ****
  • Posts: 322
  • If your not crashin' your not trying hard enough..
    • Midwest Heli Boyz
Re: Landing Gear dampners
« Reply #6 on: March 09, 2016, 02:21:39 PM »
I only run 2 at the rear of the heli and they are not glued in place. I can do a sliding auto no problem with 2 at the rear only.
Team Synergy
Team Scorpion
Team Dee Force Aviation
Team YS Performance USA
Looking for a fuel Sponsor