servo tail control rod hitting mid range needle

[turner2]

I just built an n5c install the ball on the servo horn in the proper hole binds on the mid range needle valve. I had to move the ball in one hold to correct this. Is this going to effect my tail hold?

[Darren Lee]

Did you install the pivot ball on the upper side of the bellcrank?

[turner2]

Yes it is on the top. I was wondering if I could twist my carb enough to get clearance

[Darren Lee]

Yes rotating the carb slightly is fine. I've had to do that as well.

[cml001]

May wanna double check that the tail servo horn is at 90 degrees and the ball is at the correct distance on the horn..

[turner2]

Rotated carb tail control rod clears , maiden flight tomorrow , thanks guys

[cml001]

Awesome! Glad u got squared away! Ur gonna love this bird... N5C kicks ass!