Nice Gary! Could you post the electrical and pinion setup for all to see?
Hacker A40 10L , 1100KV. 16 tooth pinion, talon 90, and 6s/5000 venom packs.
this is an old motor, and was one of the first A40's from about a decade ago. The current version is improved and would be more efficient, but this one works so I'm not going to spend $120 to replace it.
The caveat is that the shaft on these motors is short so i cut a length of 5mm shaft to make it long enough to extend through the support bearing, and green locktited that shaft extension into the pinion. I think it was a spare shaft for E5 front transmission that I cut to length.
Tail is using a 15 tooth pulley from stock drive products to get 6.0 to 1 ratio for the lower headspeeds.
