November 22, 2024, 11:04:42 PM
« previous next »
Pages: [1]

Author Topic: E6/E7 TT How far to push in alignment during build  (Read 1611 times)

Offline cbhelo

  • Newbie
  • *
  • Posts: 2
E6/E7 TT How far to push in alignment during build
« on: July 19, 2012, 02:30:57 AM »
Working on the final stages of my new E7 TT Kit and working on the TT install.  The TT supplement install guide says
"1. Align boom flush with front boom clamp"
When doing my N5C build it was pretty easy to see when the boom wasn't flush and you could adjust.  With the transmission, I'm having a hard time seeing the boom.  Should I just push it all the way in or push it all the way in and back out 2-3mm?  Or other? 
Probably minor... but would like to get it right!
Thanks for any tips!
Logged

Offline steffgiguere

  • Field Representative
  • Synergy Hero
  • ****
  • Posts: 1373
Re: E6/E7 TT How far to push in alignment during build
« Reply #1 on: July 19, 2012, 06:45:20 AM »
Push it all the way in, then you should be able to see it, then pull it back out until it is flush with the front boom clamp.
Logged
Team Synergy, Canada

Offline Jean-Luc Bolduc

  • Field Representative
  • Synergy Veteran
  • ****
  • Posts: 614
Re: E6/E7 TT How far to push in alignment during build
« Reply #2 on: July 19, 2012, 08:05:08 PM »
Yes, all the way in flush, but backed out 2mm by looking into the frame  before bolting in the TT front trans.
Logged
Team Synergy
Pages: [1]
« previous next »