cgy 750 tail tuning help

[Chris Sexton]

I have been accused of being a servo Nazi, but I'm going to tell you the aligne DS 650 does not play well with the CGY. The cgy needs a good quality narrow center pulse servo.

The 650 works on a lot of FBL a systems, but I wouldn't run anything but A 760 center pulse with the CGY


Sent from my iPhone using Tapatalk

[anthony]

I don't like align servos but it came with it when I bought it and I haven't had the funds to change it just yet , but be assured it is the first thing on my list to go , what would you recommend for a decent 6v servo?
Anthony

[anthony]

going through my tail mechanics tonight the actual tail is perfect not a hint of any resistance throughout the entire tail motion, I do feel some resistance from the pushrod , I think I will try and find a carbon one I can use to replace the original to free that up some , its not that bad but under flight conditions you just don't know
Anthony

[Chris Sexton]

Futaba BLs251sv is the best 6v tail on the planet of you ask me. But I admit I'm a bit of a servo nazi.

Most of the good HV tails that are 760 center pulse work well on 6v.


Sent from my iPhone using Tapatalk

[Rodney Kirstine]

I agree with Chris. That servo and the CGY-750 is not​ a good combination.

[anthony]

is that servo discontinued ?

[Robert "Full" Montee]

What are you powering your servos with and what is the exact voltage?
BLS251SB and BLS276SV are current and available.

[anthony]

6.1v hobbywing esc

[Robert "Full" Montee]

You are running a voltage range that fits the BLS276SV Futaba tail servo.

[anthony]

ok thank you , when I can afford it I will give it a try,

[anthony]

I realise that this is the wrong forum for this question so I will keep it short, I changed the pushrod on my x5 to a carbon rod supported in the middle , tail is better but I have to tune out the ccw bounce ( cnt dly out I believe is the parameter) I have been noticing a head shake at low rpm which is getting worse so I think I have to change my dampeners too , this I think will solve my problem , thank you for all of your time , I think that is all , until I get a 516 anyway
Anthony

[Robert "Full" Montee]

Good to read, enjoy flying!!

[Cliff Chmiel]

I had awesome luck with the bk line, 7001-7005   and the small ones for my little gobins 420 and 380. have the 7001 in my E5s, E7se,and my 766, Have MKS in my scale 800 222

[Rodney Kirstine]

I currently have BK tail servos in all my models, as well, with great success.