November 21, 2024, 11:13:27 AM
« previous next »
Pages: [1]

Author Topic: What are your 516 VBAR settings?  (Read 2479 times)

Offline firefighternickn

  • Newbie
  • *
  • Posts: 17
What are your 516 VBAR settings?
« on: January 24, 2020, 11:57:03 PM »
Right now, my gain for cyclic is around 60, but my tail is around 92. Not getting a wag on the tail, but its not holding as tight as I thought it should be. Is this too high for gains?
Logged

Offline smittylube

  • Field Representative
  • Newbie
  • ****
  • Posts: 19
Re: What are your 516 VBAR settings?
« Reply #1 on: April 22, 2020, 09:44:27 PM »
Late reply,
I would first ask what head speeds you are running. If its lower the speedup pulley can help a bunch.
Other things to consider are servo speed and torque and is everything silky smooth travel.
Also the governor can mess with the tail at times.
Logged
Steve Smith

Offline Grimmy

  • Field Representative
  • Full Member
  • ****
  • Posts: 204
Re: What are your 516 VBAR settings?
« Reply #2 on: April 24, 2020, 07:54:11 AM »
Make sure you've done the first 5 steps: https://www.vstabi.info/en/node/2043

I run low headspeed, 1700, 1900, 2050 and I went through the general tweaking order, from the link above, and the tail was rock solid.  I am running the speed up tail as well, due to my low head speeds.  It should be your stop gains too.
 
Logged
Pages: [1]
« previous next »