Author Topic: Electronic Assembly Help (Read 14928 times)

Hendo67 · « **Reply #90 on:** January 06, 2013, 10:05:22 PM »

You can also remove the servo plug to make it easier to slip through the loom. Either tape or heat shrink over the wire ends so they won't snag. You can fit 2-3 servo leads through the smaller loom this way. I also like to use short (1/2") bands of heat shrink on my wire bundles inside the loom. One about every 3-4".

NKY Heli Guy · « **Reply #91 on:** January 06, 2013, 11:28:56 PM »

Not sure I understand the heat shrink do you have a photo by chance

Sent from my iPhone using Tapatalk

RichL · « **Reply #92 on:** January 07, 2013, 01:21:35 AM »

The heat shrink just keep the wires flat inside the loom. You can cut small bands about a 1/4" wide from a piece of heat shrink tube.

Rich

Hendo67 · « **Reply #93 on:** January 08, 2013, 09:50:34 PM »

Rich is correct- they are just to bundle the wires. It won't cut in like zip ties and slips through the loom.