E5 Setup

[povern]

Just ordered an E5, and I will be stretching it.

Have a few questions.

I have a pyro 700-45 motor, and it has a 50.8mm od. Will that be OK? I know the frames are 52, but that seems tight.

The 700 is a 450KV motor, going to go with 12s. (3000mah)  Will the 14 tooth be OK?

The 700-45 also has a 6mm shaft, are the pinions 6mm?

Assuming I will need the tail speed up gears.

Going with a Heli Jive, Futaba 251 and 451, VControl and Silverline vbar.

[Ktsn]

Hello

According to several configurations done by Synergy family members, your setup will be fine.
You will have a max rpm between 2050 and 2150 that is good for stretched e5.

The Pyro is fine, there is enought room left, the counterbearing will handle it straight.
Regarding the shaft, a minimum of 33mm is required for the counterbearing and it's 6mm for pinion.

Have fun


Publié avec mon iPomme via Tapatalk

[povern]

Thanks, KTSN

[Ktsn]

Your're welcome !
With this setup, your E5s will be great.
Don't forget the 4,5:1 tail ratio upgrade.



Publié avec mon iPomme via Tapatalk