Vbar neo and futaba rpm sensor on n5c

[Terryla]

I'm new to nitro and im building an n5c with a vbar neo.
This mite be a question for mikado but I thought someone here mite be able to help.I'm using the neo gov with the vbar controll and was wondering if I can plug the futaba magnet gov sensor into the rpm sensor and it work?.thanks for any help.

[Chris Sexton]

Hello!

Yep Futaba sensor works great!


Sent from my iPhone using Tapatalk

[Kevin Dalrymple]

That is what I am using.

[Terryla]

That's good to hear someone else is using the same set up because I will all kinds of questions on this.thanks for ur reply s.

[helicrazy2]

you have to use a volt step down for the magnet sensor

[Kevin Dalrymple]

you have to use a volt step down for the magnet sensor

I am not. I just plugged it in. I have been using it on my N7 since IRCHA.

[Mike Spano]

you have to use a volt step down for the magnet sensor

I am not. I just plugged it in. I have been using it on my N7 since IRCHA.

me either. actually I think its the other way around. some of the sensors had issues on the silver because the voltage was too low.

[Pilot error]

sorry to hijack but could one y connect the wire from the futaba sensor to send signal to the vbar and a futaba telemetry data decoder? or should one use a second pickup to get telemetry data to the rx/tx?