November 21, 2024, 06:26:34 AM
« previous next »
Pages: [1]

Author Topic: 516 to 556  (Read 2482 times)

Offline woodscra

  • Newbie
  • *
  • Posts: 47
516 to 556
« on: January 05, 2020, 06:50:26 PM »
What is a good setup for 6s?
Reuse an existing 1350kv with 16t?
1200kv with 17/18t?

90mm tail blades and 18t tail pulley.
Logged

Offline alan

  • Sr. Member
  • ****
  • Posts: 275
  • Team Helilids
Re: 516 to 556
« Reply #1 on: January 05, 2020, 07:01:08 PM »
If you have the 1350 go with it. Should be fine with the 16t pinion. I ran my 516 at a lower than most head speed so when I stretched it I did not change the pinion. I run the pyro 600-1200. I opted for the 20t pulley and kept the 80.6 tail blades.
Cheers
Alan


Sent from my iPhone using Tapatalk
Logged
Team Helilids RC

Offline woodscra

  • Newbie
  • *
  • Posts: 47
Re: 516 to 556
« Reply #2 on: January 05, 2020, 07:21:07 PM »
Thanks.
No tail hold problems with the standard tail pulley, 80 blades and lower head speed?

What is your headspeed?

Which pinion?
Logged

Offline alan

  • Sr. Member
  • ****
  • Posts: 275
  • Team Helilids
516 to 556
« Reply #3 on: January 05, 2020, 07:34:50 PM »
No problems at all. My bad. 18t pulley.

1950/2100


Sent from my iPhone using Tapatalk
« Last Edit: January 05, 2020, 07:39:24 PM by Alan »
Logged
Team Helilids RC

Offline woodscra

  • Newbie
  • *
  • Posts: 47
Re: 516 to 556
« Reply #4 on: January 05, 2020, 07:49:40 PM »
Which motor pinion?
Logged

Offline alan

  • Sr. Member
  • ****
  • Posts: 275
  • Team Helilids
Re: 516 to 556
« Reply #5 on: January 05, 2020, 08:12:09 PM »
16t


Sent from my iPhone using Tapatalk
Logged
Team Helilids RC
Pages: [1]
« previous next »