Hi all,
I have decided to convert N9 #1 to FBL...suprise...suprise
. My other N9 has a Scott Gray Reactor X2 however I don't want to buy another one of these for the conversion process. So I would like to keep the Fromeco Arizona that is installed at the moment to keep $$$ down.
However I am little confused about the wiring
. For the record I have the following; CGY750, R6208 SBUS Rx, BLS451's cyclic, BLS254 throttle and BLS251 for tail. I have a Fromeco 5200mAh LiIon 7.4V Rx pack.
I want to run the cyclics on 6V and the tail on 5V. Throttle I am not too worried about.
With the GY701 I have the 6V source (Red connector) on the SBUS cable between (inline with) the GY701 and Rx. The 5V source (Green connector) is plugged into the battery/Ch 8 port on the Rx.
Can I do this the same with the CGY750? Or do I plug the 5V source (green connectors) from the reg in between the CGY750 and the tail servo to run it on 5V?
Sorry if I have confused anyone.
Thanks for your help.
Kind Regards
Scott
