Author Topic: N5c Elevator Bell Cranks (Read 1580 times)

Rocky · « **on:** July 11, 2012, 12:17:51 PM »

I ordered some new inside and outside elevator bell cranks (part numbers 610-222 and 610-226) for my N5c and the 4mm set screws wont fit.
Looks to be 3mm tapped holes in them.
Was there a change in the part?

Tommy Wagner · « **Reply #1 on:** July 11, 2012, 04:29:57 PM »

Don't think there was a change in the part number but the N5 (not the N5c) did come with 3mm set screw.

Tommy

Sent from my iPhone using Tapatalk

Kevin Dalrymple · « **Reply #2 on:** July 11, 2012, 09:48:14 PM »

There was no change. The N5C comes with 3mm holes. You can drill them out and tap the for 4mm set screws. There is a tip on this in the N5 tips and tricks on the Synergy home page.

Tommy Wagner · « **Reply #3 on:** July 12, 2012, 06:00:06 PM »

I did have to drill and tap this in the N5 but the N5c comes with 4mm set screw.

Tommy

Sent from my iPhone using Tapatalk

[attachment deleted by admin]

Rocky · « **Reply #4 on:** July 12, 2012, 07:25:14 PM »

Thanks guys looks like I got some old stock.
Looks like I will just drill and tap them for the 4mm screws.