October 31, 2024, 07:02:34 PM
« previous next »
Pages: [1]

Author Topic: Elevator servo wheel lower ball  (Read 1614 times)

Offline jfluegel

  • Newbie
  • *
  • Posts: 2
Elevator servo wheel lower ball
« on: August 28, 2012, 01:12:08 PM »
I'm using DS610 servos on my N5C and on the elevator servo (balls on inside of wheel) the lower ball rubs on the servo case. Is it better to put a washer between the splined shaft and wheel or grind the face of the ball down? Or is something else wrong?
Logged

Offline Darren Lee

  • Field Representative
  • Synergy Veteran
  • ****
  • Posts: 620
Re: Elevator servo wheel lower ball
« Reply #1 on: August 28, 2012, 05:49:32 PM »
Unfortunetely, that's normal for Align servos.  I just let mine rub but I think grinding the ball a few thousandths would be the way to go.  Futaba servos have plenty of clearance. :)
Logged
Team Synergy / Rail Blades / Morgan Fuel

Offline craig1980

  • Newbie
  • *
  • Posts: 22
Re: Elevator servo wheel lower ball
« Reply #2 on: August 29, 2012, 09:57:31 PM »
I had one rub with the align servo also.  I grinded it down and it has been fine.
Logged
Pages: [1]
« previous next »