November 22, 2024, 02:59:28 PM
« previous next »
Pages: [1]

Author Topic: 8mm Pinions  (Read 1805 times)

Offline mahbouni

  • Newbie
  • *
  • Posts: 7
8mm Pinions
« on: November 22, 2012, 03:50:43 PM »
Are there any plans to produce pinions with 8mm bore so we can try the Pyro 800-48?
Logged

Offline Chris Sexton

  • Factory Specialist
  • Synergy Hero
  • *****
  • Posts: 2729
  • Admiral, There be whales here!
8mm Pinions
« Reply #1 on: November 22, 2012, 04:06:01 PM »
I don't think the pyro 800 fits between the frames. Frame width is 60mm isn't it?




Sent from my iPhone using Tapatalk
Logged
Chris Sexton
Synergy Factory Specialist / Rail Blades / Team Scorpion

Offline Jean-Luc Bolduc

  • Field Representative
  • Synergy Veteran
  • ****
  • Posts: 614
Re: 8mm Pinions
« Reply #2 on: November 22, 2012, 08:54:55 PM »
62 mm spacing, but 800 is 63mm. You'd have to put washers or spacers  to widen frames to make it fit.
Logged
Team Synergy

Offline Jean-Luc Bolduc

  • Field Representative
  • Synergy Veteran
  • ****
  • Posts: 614
Re: 8mm Pinions
« Reply #3 on: November 22, 2012, 08:56:11 PM »
Pinions could be drilled a bit, not sure if ok to enlarge hole from 6mm to 8mm.
Logged
Team Synergy

Offline Chris Sexton

  • Factory Specialist
  • Synergy Hero
  • *****
  • Posts: 2729
  • Admiral, There be whales here!
8mm Pinions
« Reply #4 on: November 22, 2012, 09:13:42 PM »
Quote from: 4cyclic on November 22, 2012, 08:54:55 PM
62 mm spacing, but 800 is 63mm. You'd have to put washers or spacers  to widen frames to make it fit.

Ahh I was reading the spot for max motor on a different thread. Thanks for the clarification.


Sent from my iPhone using Tapatalk
Logged
Chris Sexton
Synergy Factory Specialist / Rail Blades / Team Scorpion

Offline Jean-Luc Bolduc

  • Field Representative
  • Synergy Veteran
  • ****
  • Posts: 614
Re: 8mm Pinions
« Reply #5 on: November 23, 2012, 07:55:13 PM »
it's a really nice motor, no doubt. Keep us posted if you decide to go and do the trial.
Logged
Team Synergy

Offline mahbouni

  • Newbie
  • *
  • Posts: 7
Re: 8mm Pinions
« Reply #6 on: November 24, 2012, 06:24:49 AM »
If the motor is too wide then I'm not going to mod anything. Was just wondering if it will work. There is a Pyro 750 being tested by some pilots over here.
Logged

Offline Matt Botos

  • Synergy Hero
  • **
  • Posts: 1573
    • Matt Botos
Re: 8mm Pinions
« Reply #7 on: December 16, 2012, 12:56:40 PM »
The Pyro 750 would be a better option! It will have more than enough power for the E7.

:)
Logged
Pages: [1]
« previous next »